Hits: 65

GT20 JCM Bill Acceptor

  1. Power off the terminalby toggling the highlighted on/off switchabove the keypad to the down position (leave terminal off until below steps are completed).
  2. Open the bill acceptor doorwith the security keyand tilt the assembly down. 
    G20 JCM Bill Acceptor Door Open H1000
  3. Remove the acceptor moduleby pushing up the silver latching and pulling straight out.
    G20 JCM Cash Box Pull Out H1000
  4. Place your fingers on the black groove and chrome barand squeeze to releasethe bill acceptor read head.
    G20 JCM Cash Box Removal H1000 G20 JCM Cash Box Lift H1000
  5. Gently lift the read head from the bill acceptor- this allows the clearing of jammed bills.
    G20 JCM Bill Removal H1000
  6. After the bill acceptor has been cleared, gently slide it down into its locked position. If the bill acceptor is put into its proper position it will reset after 10 seconds.
  7. Power on terminal by toggling the on/off switch above the keypad to the up position.

Frequently Used (Top 10)

Recently Published

Recently Modified